UNSOLVED

shadhzaman

updated

5 years ago

S

shadhzaman

1 Rookie

•

2 Posts

0

874

October 18th, 2021 11:00

PS4100x - Copy to spare being denied

We have a really strange problem in our hands. In our PS4100x, after a SMART error happened in one of the drives in our RAID array (Disk#17), and we are constantly getting "A copy-to-spare request is being denied for drive 17 because the drive is not part of a RAID set". 
Drive 17 is part of the same RAID set the spare (Disk#14) is, which is online and recognized as a spare (I even tried clearing the labels, and the CLI told me it was already a part of it, and GUI confirms it by being that option greyed out). Both drives are EQL specific drives.
Any thoughts on what I can do next? Maybe try a hot swap of the affected drive or the spare with a EQL drive?

  • dwilliam62

    6 Operator

    •

    1516 Posts

    •

    6374 Points

    713

    1

    Posted October 18th, 2021 13:00

    Hello, 

     What EQL FW is that array running?  I suspect an older version.  What RAID level?  I'm guessing RAID5 or RAID6?   What size drives? 

      If it is older firmware and the failing drive is #17, I would suggest pulling out that drive and forcing a rebuild vs. copy-to-spare 

     Regards, 

    Don

     

  • shadhzaman

    1 Rookie

    •

    2 Posts

    657

    0

    Posted October 25th, 2021 11:00

    Hey,
    Thanks for the reply. It is running FW version 8.1.10 (R436828), RAID is 50
    Is it safe to hot swap or should I turn everything down and then swap it?
    I am afraid of the data loss for a possible hot swap but the rebuild downtime also worries me - some  data here are vital (we would be swapping soon)

  • dwilliam62

    6 Operator

    •

    1516 Posts

    •

    6374 Points

    644

    0

    Posted October 26th, 2021 06:00

    Hello, 

     Yes, it is safe to hot swap drives.  You only have to remove the failing drive to force a rebuild.  You don't actually have to swap their positions.   

      Please copy and paste the output of this command.  GrpName>support exec "raidtool" 

       With RAID50 there should be two spares.   

       The clear label is only useful when you install a drive that was once part of another RAIDset.  The labels can't be mixed.   I.e.a drive from another EQL array was installed, and the old array wasn't reset first. 

     Regards,

    Don