yep, USM

Hmm ussie again.

"Dual control station configuration is not currently supported. Contact your support organization for other upgrade options."

May be i have to power down CS1?

Which enablers?  If they are for the Block portion of your system, choose Install VNX for Block, not Install VNX OE.  The dual control station check should be skipped.

See this section in the Update Software doc at www.emc.com\vnxsupport

For the Storage System type select:

◆

VNX or VNX for File to download updates for both file and block components, or

◆

VNX for Block to download updates for Block updates only.

Note:

You can still use USM to upgrade only the block side or add enablers, even with a dual CS system.

i had the same issue the other day when i was trying to upgrade FLARE, i guess it's preventing enabler installation as well. I have not tried to shut on CS down but i don't think it will matter. CS knows it's configured in HA configuration. Give it a shot.

Hello

When you choose "Install Software" in USM you will got following choice:

Install VNX OE

Install VNX for File

Install VNX for Block

You should select "Install VNX for Block" to install enablers

Alex

Hello,

How to skip message with "Dual Control station" if i want to upgrade VNXOE File and Block software(firmware)? 

Hello

You can't upgrade NAS code (VNX OE for File) from USM with dual CS

You can do it in CLI.

If you want to upgrade VNX OE for Block or install any block enablers choose "Install VNX for Block" in Softrare Upgrade section.

Be aware you should upgrade VNX OE for File first before you will upgrade VNX OE for Block cause OE for File should be compatible with OE for Block.

Take a look at upgrade procedure froms VNX Procedure Generator for details.

Best regards,

Alex

Hello again,

From where i can download 05.31.000.5.007 version on  Web site i can download only last version 011.

Why would you want to install 007 when 011 is newer ?

If you do need a version that’s not on the download site you need to contact support direct – asking in the forums doesn’t open a service request