UNSOLVED

Riese6464

updated

22 years ago

R

Riese6464

1 Message

0

1188

October 21st, 2004 15:00

GX-270 and installing Third hard Drive problems

Hello all
THis is my first time using these forums, if these forums are as good as other companies I will have my answer in no time.  Ok here is the problem
 
I have a gx-270.  I brought two hard drives from home that I am trying to put into my cpu.  The first drive went in next to the computers factory HD and it works fine.  The problem I am having is with the secondary IDE.  When I install the new HD it makes both drives "unknown devices" in the bios and the windows does not see them.  I then went to changing the jumper settings on the CD-rom and the HD.  I tried cable select, both master and slave on each device.  Alternating them accordingly.  All with no success.  So Im wondering if this is a problem that can be fixed?  I figuere that it's probaby something simple.  I hope you guys can help.
 
 
Thanks
Jerald Pierucci
  • pinto1982

    15 Posts

    108

    0

    Posted November 15th, 2004 05:00

    ok...first to be safe put the drive you put on the secondary and put it on the primary....with the jumper set accoringly with the OE (if oe is cable select put the new on cs and if the oe is on master put the new on slave) and if this arrangment works with the drive you put on the secondary ide ....you now know the drive is ok......now pending on you..... leave that one there or put the other back. now with what ever one you have out put it on the middle connector of the secondary as slave and you rom on the end as master....power up and head for bios...and with not being familar with the gx 270 find go down (like most dell bios do instead of tabbing over) and you sould have 4 drives primary master and slave saying what ever you have installed ...and if it dont look right change them to AUTO (more than likely they are set to USER or a preset) and then on the secondary master and slave you might see "unknown device" or what is actually there.... see what they are set on ....if one of the presets or user .....dont think twice about it change em to auto....then save bios and reboot
     
     
     
    hope that works for ya ....if you have already tried this im sorry for trying to teach something you already knew...but let me know either way....