I've got a new PE2950's server. I'm trying to re-install Windows Storage Server 2003 R2 via the "Installation & Servermangement CD Version 5.0". After boot up by the CD,
The boot options of :-
1. Server Assistant
2. Server Assistant with CD Media Check
3. Skip CD boot - Boot to hard disk
The boot option "1" was selected. Upon choosing this selection it shows
To being replication, please insert your replication floppy.
Replication will begin once the system has booted.
I've got an issue at this part. Firstly, where do I go about to source for a replication floopy. The PE 2950 has no floppy as well. No idea, on how to proceed on.
Hope you guys out there can provide some assistance. Many thanks.
1. Insert the "Dell PowerEdge Installation and Server Management" CD
into the CD drive and reboot the system. If the system is
supported by the CD, a graphical user interface (GUI) that
displays a photograph of the system is shown.
2. Keep all configuration information for the system ready.
3. Click "Continue" and follow the instructions to complete the
installation. Context-sensitive help is provided on each page.
4. Insert the operating system CD when asked by the system.
5. For Windows, SUSE Linux Enterprise Server and Red Hat Enterprise
Linux systems, remove the operating system CD from the CD drive
before clicking "Finish."
6. The system reboots and the unattended operating system
installation continues.
7. When the installation is complete, your system is ready for use.
Unless it has changed on the 9th gen servers, Windows Storage Server R2 is reloaded via the USB key suppied with the server, instead of using the ISM CD.
Storage Server R2 is treated different than standard Windows R2
Mark_A_Smith
2 Intern
•
827 Posts
325
0
Posted September 13th, 2006 12:00