
UNSOLVED
Problem: RAID 0 with one partition for OS and data
Inherited a Dell PowerEdge 6450, PERC 3/DC & PERC 3/DCL RAID Controller, 2 x PERC LD 0 PERCRAID SCSI Disk Devices. RAID 0 array configuration.
Disk 0 = 70GB, basic, single partition for OS (Win Srvr 2003) & all data files.
Disk 1 = 35GB, dynamic, single partition dedicated for Volume Shadow Copy.
I want to add some fault tolerance to cope with an OS failure (e.g. so I could freshly reinstall the OS without affecting the data). As this is Ops Master for the domain and the only server the organisation has, I'd like to leave the OS on C:, but this is the larger disk (70GB). Considering a complex solution involving reformatting and partitioning of Disk 1 so I can install 2000 or XP and run PQMagic 8.0 to resize Disk 0 and create a second partition for the data. Then, reformat Disk 1 again and move the pagefile, logs, etc onto that disk. This gives me increased performance as pagefile, exchange files on separate disk, plus some separation of data and OS.
In this case, does RAID 0 config have any implication (I've only worked with RAID 5 before) or is there perhaps a less complex solution which would enable me to run the OS on a smaller partition, make use of the remainder of the space on that disk for data, and move the page/log files to Disk 1? Ignore Vol. Shadow Copy in all this...
NB: funding is tight, but if the above isn't workable I may be able to purchase an additional disk. If so, how should it be incorporated into the existing array configuration?
Thanks.
Responses (2)
Solutions (0)

richard_bahcic
7 Posts
309
0
Posted June 18th, 2004 08:00
The operating system on the source partition is a server version.
Cannot Copy or resize the Filesystem of a Server.
Use ServerMagic instead.
Hope this helps.
Bye,
Richard