UNSOLVED

wsbolt

updated

20 years ago

W

wsbolt

2 Posts

0

5146

May 21st, 2007 23:00

PowerEdge 2650 w/ Perk 3/DI w/4x37gb Raid 5, adding additional drive to array

I have a Power Edge 2650 Perk 3/DI with 4x37GB drives the array is Raid 5.  The drives are set as Basic and not dynamic, can I add an additional 37GB drive into the array without distroying the container and loosing all the data?  This is an online machine and cant afford to take it offline for very long or risk loosing its data.  The Array is around 95% full now, and quickly running out of space.  We need some type of solution of adding an additional drive to the array or adding an additional drive so it will show up as another physical drive on the server.
  • NetFodder

    12 Posts

    83

    0

    Posted May 24th, 2007 18:00

    I'm having to use a little detuctive reasoning to figure out confusing 2 technologies. The basic/dynamic features are the disk functions of windows. If you're using your Perc3 then the RAID is controlled by the hardware and not the operating system. If the operating system was in charge of the raid, then the drives would have to be dynamic for it to even be a raid system. So here's the question. What is the configuration of the drives. IF, all 4 drives are configured as a single drive C:, Then you're pretty much not able to do it. However, if you have 2 containers build across all 4 drives. For example, container 1 is say a 18gig using 9 gig of each of the 4 drives, With a container 2 using the rest of each drive to create a second raid 5 container. Then you can do it, but the data will no longer be raid covered. You would simply upgrade the disks in windows to dynamic and then you could add the additional drive to the second container as an extended volume. If you still want the hardware fault talerence then add 2 new drives, use the perc to create a mirror set out of the two and use windows to extend the volume.