
UNSOLVED
U4025QW: Thunderbolt video fails on first connection to MacBook Pro, works after reconnect
I’m having a persistent Thunderbolt connection issue with my U4025QW when using it with Apple silicon MacBook Pros.
The behavior is very consistent:
On the first connection, the monitor reports "No Thunderbolt signal"
The MacBook still receives power from the monitor
If I unplug the Thunderbolt cable and reconnect it, video almost always works immediately
If not, then a third time works
After a successful connection I can disconnect/reconnect within a short window of time without seeing the signal loss. But if the display goes to sleep, then I'm back to first connect showing "no signal".
I've experienced the same behavior on three different MacBook Pros:
- M1 MacBook Pro (no longer have this machine)
M4 MacBook Pro
M5 MacBook Pro
All of them exhibited this behavior.
My setup:
- Currently on macOS 27 (but saw same issue on macOS 26 and 15)
Firmware: M3T105 (latest)
Apple Thunderbolt 4 Pro cable (also tried the included Dell TB cable - no difference)
Native 5120×2160 resolution at 120 Hz currently (was 60Hz on the M1, max supported)
Thunderbolt used for video, USB, and power delivery (USB C webcam plugged in to monitor)
Monitor was purchased in March, 2026 and has always had this issue.
Things I have already tried that made no difference:
Updated to the latest monitor firmware (M3T105)
Installed macOS driver on my machine
Set Thunderbolt Daisy Chain -> Optimized in the settings (based on suggestion in this community post)
Disabled automatic input selection and manually selected Thunderbolt
Tested with multiple MacBook Pros and multiple TB ports on each
- Tried multiple TB cables
- Power cycle monitor, disconnected for 30 mins
- Factory reset the monitor
- Dell support chat (see below)
The fact that the monitor successfully provides power during the failed connection, and that simply disconnecting and reconnecting the same cable almost always restores video, makes this look like an intermittent Thunderbolt/display initialization issue rather than a basic cable-detection or power-delivery problem.
I contacted Dell support via chat, but the troubleshooting went nowhere and was a very frustrating experience, because the support rep kept repeating that the monitor is only compatible with macOS 12 and 13, based on the original U4025QW user guide from 2024, and that I need to reach out to Apple for support instead. This is of course absurd, because these are deprecated and unsupported OSs, and no modern Mac laptop would even be able to run them. The product page for this monitor just states the monitor supports macOS with no exact version pinned.
Has anyone else seen this specific pattern with the U4025QW? Any suggestions on what else I should try?
(I’m not looking to switch to HDMI, use a separate charger, or add an external dock, since that defeats the purpose of using the U4025QW as a Thunderbolt hub monitor.)
2 people also have this problem
Responses (1)
Solutions (0)

Psoas
1 Rookie
•
1 Message
•
5 Points
7
0
Posted October 8th, 2026 01:16
Same issue here purchased this device 2 weeks ago , they have replaced another one . Both monitor worked the very first connection through thunderbolt but none since then. Very frustrating.
I have tried with Macbook Air M1 x 2 ( devices ) and one MacBook Air M5.
I did all troubleshooting as above but no success. Apple denies any issues their side. Dell seriously need to work on this issue.