1. I initially only plugged in the DVI from the monitor to the card, and everything worked fine. But when I turn the computer off, the monitor does not go into Power Save Mode...it just says "No DVI Cable" and I have to turn the monitor off manually. If I re-plug in my old 2407, it goes into PowerSave Mode automatically, like it always did.
2. Then I plugged in the VGA cable, in addition to the DVI cable, which is how I had it set up with my old monitor. Now when I boot it up, the VGA works fine, but I can't get DVI to work at all. If I select the DVI input on the monitor (input 2), it will ONLY go into Power Save mode. If I unplug the DVI cable, I get the "No DVI Cable" message. If I shut down the computer and the monitor, then only plug in the DVI cable, when I reboot the computer, the monitor stays in Powersave mode, even with Windows booted up. But the VGA works fine. When I shut off the computer, the VGA connection goes into PowerSave Mode like it should.

Like I said when I plug in my old Rev 02 monitor, everything works fine like it always did. I tried switching cables. I did notice that one of the pins on the DVI connection on the new monitor is either missing or set back further then the others...not sure if that has something to do with it. I'd like to figure something out before I have to ship my old monitor back to Dell on Friday.