
UNSOLVED
Dimension 8200: Removing RAM issue
Hi... My father and I both have older Dimension 8200s. Presently he has 512 MB RAM in his machine, and I have 1 GB RAM in mine. Now I'm trying to actually give him 512 MB RAM (via 2 256 MB PC800 RDRAM) so he can upgrade his machine to 1 GB RAM - the reason is I'm giving my Dimension 8200 to my wife's parents, and they don't need 1 GB RAM (whereas my dad is still playing games on his, so extra RAM will help).
That said, whenever I take the 512 MB RAM out of my system and try to boot back up it the machine just beeps (and fails to boot). There's still two 256 MB RAM inside together, but again, the machine won't boot up (just beep).
I've gone about taking the RAM out by doing the following:
(1) Unplugging the computer and letting it sit for a little while
(2) Taking two 256 MB RAM out from the same side (I've tried both sides, and it doesn't seem to matter)
(3) Plugging it back in
(4) Booting (at which point it beeps and doesn't boot)
Once I put the RAM back in the machine boots up fine. I thought the machine would automatically detect that the RAM had changed when I removed 512 MB, but I guess that's not the case.
Any advice on how I can 'downgrade' my machine to 512 MB and still have it boot up fine is appreciated. Thanks.
Responses (3)
Solutions (0)

farmrt88
38 Posts
124
0
Posted February 22nd, 2006 15:00
Have you replaced the memory you have taken out with 2 CRIMMS. These are dummy modules that have to be placed in slot 3 and 4 in order for a system with only 2 lots filled to boot. Do a search on CRIMMS and rdram to find more information. Your fathers machine should have 2 CRIMMS in slot 3 and 4, unless regular memory is installed there. Then you could just swap the CRIMMs into the other computer.
Hope this helps