If you would like to change the iSCSI Adresses its a 3 step change
1. Assign new adresses to all phys. ethx except one (dont change eth0 yet for example)
2. Now change the GroupIP aka WKN
3. Change the last pyhs. port (eth0)
You cant change the GroupIP aka WKN (Well known address) if no phys. ports are already within the subnet. This is why you have change half of your ports first. This is tricky if you have an EQL with only one phys. iSCSI Port. In this case you setup IPv6 first.
dcampbel
2 Posts
982
0
Posted October 21st, 2015 14:00
Donald, If I do have a dedicated management port setup how may i do this same thing from the GUI?