Did you make sure that you put the vault drives back in the same order that they were prior to removing them? The order is very important. If you can't recall the order, if you have a set of spcollects you could find the serial number for each of the disks and check that they are the same.

Within each spcollect (one for SPA and one for SPB) are sets of ZIP files - the one that holds the serial number for the disks:

CKMxxxxxxxxxx_SPA_2016-01-11_11-32-25_32e01e_sus.zip

Unzip and file the file SPA_cfg_info.txt. In the file, find the line:

"NavisecCli.exe -np getdisk"

Each disk will be listed as:

Bus 0 Enclosure 0  Disk 0

Vendor Id:              HITACHI

Product Id:              HUS15606 CLAR600

Product Revision:        C7A0

Lun:                    

Type:                  

State:                  Enabled

Hot Spare:            

Prct Rebuilt:          

Prct Bound:            

Serial Number:          LXYK6ZZL

You want to look at the serial numbers for disks 0 to 4 - these are the vault disks. Verify that the serial numbers match the slot that they are in.

glen

amber light is blinking a few times a second. I plugged in the console cable and get error code 0x0000023c Description Pers/Jackson tech mismatch Error!. How would I find out if the utility partition is available? Can I and if so would you be able to tell me how to do a full restore on the array?

Upon restarting once more the console said something to the effect Target 3 or Drive 3 failed before the error message. I pulled drive 3 and put a spare drive in and now all is ok! Thanks for your help