UNSOLVED

MrKite

updated

19 years ago

M

MrKite

19 Posts

0

3353

October 28th, 2007 13:00

Back up question

I am going to back up a large amount of files (about 60 GB) to an external HD. I read MS' instructions on using XP's backup program and need clarification. I understand (I think) that the first backup I will run as a normal backup. After that, I can either run incremental or differential backups to keep the files up-to-date. What is the difference, and which would you advise using? The files will change, usually on a daily basis, but the changes will not be major. Thanks.
  • DELL-Chris B

    2 Intern

    •

    1109 Posts

    111

    0

    Posted October 30th, 2007 17:00

    MrKite:

    Thank you for posting your message at the Dell Community Forums.

    Take a look at the following link for more information:

    Protecting The Windows XP System and Data.

    Hope that helps.

    Regards,
  • MrKite

    19 Posts

    111

    0

    Posted October 30th, 2007 21:00

    Chris, Thanks very much for the response, I acquired that link yesterday, and it was very helpful in setting up the backup. Unfortunately, I have encountered a really weird problem. I set up the backup for normal, following the steps in the wizard. I copied the files to the external HD, it took about 1 1/2 hours for the copy and another hour for the verification. All went well, backup succeeded. Then, however, I attempted to defragment the HD with the new files. The defragmentation would not finish (hung up on 48%), and when I canceled, I got a message that the data had been lost. Also, when I analyzed beforehand, all the new files were in a giant block of red, no blue whatsoever. I've never seen that. I tried once more, changed a couple of the settings in the wizard, same result. My data wasn't reported as lost this time, defrag never got past 3%. The same files defrag just fine on my internal HD. My best guess is that the files are somehow getting corrupted during the backup procedure, but I don't know how. I have gone through this same procedure before, using a third party backup program, and never had this problem. I'm stumped.