
UNSOLVED
J
JustAnotherITGuy
5 Posts
0
1995
June 28th, 2018 22:00
X520 10GbE Not Detected in R540 Rackmount Server
Hi,
I have a brand new Poweredge 2U rackmount R540 server with 1 CPU. I purchased a 3rd party generic Intel X520-DA2 network card and attempted to install it. Unfortunately, it would not come up on the server. There was nothing in the device manager in Windows Server 2016, and no mention of the card in the hardware inventory via the lifecycle controller.
I tried it in both the motherboard PCIE slot, the low profile left riser slot, and the right full height riser slot. All to no avail. I also confirmed all the slots were set to enabled in the BIOS.
The kicker? The exact same card put in a Windows 7 system was detected and installed automatically with 2017 Intel drivers via Windows Update. Plug and play.
So, I figured that Dell servers don't support modern standards, and instead only work with Dell branded, tested and certified cards. Fair enough! I returned the card and ordered what was listed as a genuine Dell X520-DA2 card.
It was advertised as Dell Part number 01V3j card / 540-BBDR, which is listed on Dell's website as compatible with the R540. However, it behaves exactly as the generic card did. No signs of life in the server but it works fine in Windows 7.
I tried updating the firmware for both cards in Win 7 with various versions from Dell without success.
As for the 2nd card, I'm concerned I didn't get the real thing. The part number on site I purchased it from listed it as 01V3J but the actual card is labeled as 0VFVGR. It also has the number G18786-004 on it.
My questions are as follows:
1) Am I correct in assuming that Dell servers do not allow non-Dell 10gbe cards to operate?
2) If not, is there something I am missing in the default config that would prevent a standard 10gbe Intel network card from being detected?
3) If so, could someone provide a list of the exact 10GbE SFP+ cards that are compatible with this server and will be detected without issue? Also, any thoughts on whether or not my 2nd card is legit?
Thanks Much!
Responses (1)
Solutions (0)

Daniel My
12 Elder
•
6204 Posts
1745
0
Posted June 29th, 2018 09:00
Hello
540-BBDR is validated for the R540. It should contain card part number XYT17. That is the second revision of that card. The first revision of the card is VFVGR, that card is not validated for the R540. It is only validated for older systems around 10th and 11th generation.
Part 01V3J is a kit part number that contains part XYT17 and some documentation, they are essentially the same part.
It sounds like the card you purchased was listed for sale under the wrong part number.
Thanks