Dell Power Vault TL2000 ISCSI BRIDGE (tl24iscsixsas 1gb iscsi)
Hello,
Iam having trouble with my tape library iscsi bridge, my scerario are:
1- Someone configured an ip on it before then it was not being used for long and the configuration was not documented.
2-I did a factory reset on the tape so i could try the default ip that is 10.10.10.10 (i follow the Iscsi bridge configuration manual)
3- i set an ip address on my laptop (10.10.10.11 with mask 255.255.255.0) and i connected my CAT5e cable on each port of the Iscsi bridge to ping 10.10.10.10 but i was not succeed, i need help so that i can have my iscsi bridge working, and one thing i notice is that the connection between my laptop and the iscsi bridge is at 10MB os speed is that NORMAL... Help help
When you try to connect to the ISCSI Bridge are you using the ethernet port next to the sas connection on the ISCSI Bridge? If not then the Left side ethernet port is the port that you will need to use to access the bridge for setup as that is the port that is set to 10.10.10.10. It is normal for the connection speed of the management interface to be about 10mb speed.
Please let us know if you have any other questions.
I ran into the same issue as you and I was able to solve it by using a utility that Dell support provided to me called LANSCAN. This utility sends out a broadcast to the iSCSI card which then responds back with its IP address and other information. It worked really well. Contact Dell support and ask them for the utility.
I have the same problem. I can´t connect via ethernet on both ports with any ip-adress. A cisco swtch c-3750 doesn´t shows any mac adress from the iscsi-bridge. Where can I get the LANSCAN - utility.
If you connect to the default port of your iSCSI bridge, can you use the default IP 10.10.10.10 to access the management utility? If not then you will need to direct connect to the default port of your iSCSI bridge. Once that is done then you can use any LAN scan utility that you prefer & it should find the IP of the bridge.
Please let us know if you have any other questions.
DELL-Sam L
Community Manager
•
8150 Posts
•
34715 Points
1581
0
Posted July 31st, 2014 14:00
Hello carlos.maiala,
When you try to connect to the ISCSI Bridge are you using the ethernet port next to the sas connection on the ISCSI Bridge? If not then the Left side ethernet port is the port that you will need to use to access the bridge for setup as that is the port that is set to 10.10.10.10. It is normal for the connection speed of the management interface to be about 10mb speed.
Please let us know if you have any other questions.