We recently took delivery of a SC1425 PowerEdge server, and I have attempted to install Fedora Core 5 Linux on it. The installation appeared to work fine, however when I plugged in an external USB 2 hard drive and attempted the installation, it took 20x longer as it appeared to be constantly querying the USB port for the drive. When I disconnected the drive and installed, it went fast (as it should have).
Also after completing the installation, and restarting the server, when it goes into X Windows I often lose the screen completely and I can't seem to get a display back again. This does not happen during the installer however, and sometimes I will get a screen display (about 1 in 10 reboots). Clearly this is a problem for us with the server.
I suspect there are drivers needed for Fedora that I do not have. Has anyone had issues with USB ports and Video display with Fedora Core 5 Linux before and could suggest what can be done to fix this?
Plugging in a USB drive can muck up drive designations, especially during installs (since SATA, SCSI, and USB drives all share SCSI designations). I'm willing to bet the video problem is unrelated. I'd start fedora in run level 3 (text mode) then remove the file /etc/X11/xorg.conf then run system-config-display and set your display settings manually, or at a lower resolution than your monitor supports, and just work your way back up. I never start in X just in case of problems. If you don't know what to do to start in run level 3, post back to this board and I'll elaborate.
--Walt
That would be your best bet. I've had USB discs being plugged in causing problems with how the swap discs are named. I'd advise a clean install without any USB discs plugged in (except for CD/DVD) and then that should take care of the disc problems.
OK reboot the system
When the grub countdown screen appears press to get to the grub kernels list
Highlight the kernel you wish to boot to and press e. Scroll down to the line that begins with "kernel" and press e to edit that line. Then on that line delete all the words after root=label=/ (they should be something like "rhgb quiet") then add the word single
Then press enter then b to boot. This will put you in single user mode (init 1). The first thing you need to do is edit /etc/inittab. On or about line 18 you will see something that looks like:
id:5:initdefault
change the number to 3 and save your changes.
Then edit /etc/grub.conf (just like above, remove the stuff on the kernel line after root=label=/)
after this is done, you just reboot the system and you should restart in runlevel 3 then you can set the video like mentioned before.
good luck
--Walt
Just out of interest.... When you say that having a USB2 external hard drive connected during installation can mess up Linux because of SCSI drives, are you saying that if I re-install Linux without it connected and connect it afterwards, that it should be ok?
iacullwd
25 Posts
441
0
Posted September 6th, 2006 20:00
--Walt