UNSOLVED

CRA-ARC

updated

19 years ago

CA

CRA-ARC

1 Message

0

2380

April 7th, 2008 14:00

RAID 5 Dis-Array

Hello,

We recently had a raid configuration mishap.
Someone removed the 4 drives without noting the order from a Dell 6600.

Is it possible to recover from this error by either simply replacing the drives in any order or by using some method to discover the drives order?

Any help would be greatly appreciated.

Thanks
Christopher

  • Dev Mgr

    6 Operator

    •

    9308 Posts

    •

    3 Points

    187

    0

    Posted April 7th, 2008 15:00

    Though it's highly recommended to put the drive back in the same order, theoretically it's possible to put the drives back in in any order and the raid controller (I assume you have a PERC3 or PERC4) picks up on the drive config and works just fine.

    What I would do is this:
    - keep the drives out (or pull them out again if you already inserted them)
    - power up the server
    - go into the PERC bios
    - clear the config from the raid controller (the drives have this config as well)
    - save and exit
    - power down the server
    - insert the drives
    - if the PERC comes up about different configurations between the disk and the raid controller, select to use the config of the disks
    - let the server boot up

    This is obviously at your own risk, but this is the easiest to try and has a good chance of working if nobody cleared the config on the PERC when the drives were still in the system.
  • jfdnerds

    10 Posts

    187

    0

    Posted April 7th, 2008 20:00

    How do I tell it to use the config of the drives?
  • Dev Mgr

    6 Operator

    •

    9308 Posts

    •

    3 Points

    187

    0

    Posted April 8th, 2008 13:00

    If it comes up you get a choice. Read the screen to make the appropriate choice.