UNSOLVED
PowerEdge T620 GPU installation
Hello,
I am using T620 at work. I am not sure if I have the GPU enablement kit installed. I bought Nvida K4000 and installed it according to https://www.youtube.com/watch?v=oqP1goE06u8 .
When I opened the T620, I didn't see anything like PCI power cables. T620 doesn't recognize the GPU card. Could you help me with it?
Thanks,
Joowook
777
0
Posted August 19th, 2022 12:00
Thank you. Could you also tell me where I plug in the GPU power cable on the workstation? If you show me pictures, that would be greatly appreciated.
J
775
1
Posted August 19th, 2022 13:00
Thank you so much for helping me with this. So I should install the GPU in slot in red. Am I correct?
777
0
Posted August 19th, 2022 13:00
Actually I am not sure that I am correct in my previous post, as the K4000 is a 30w GPU, so the power cable shouldn't be required. So that makes me think it is slot location. Would you confirm the slot you have the card installed, as it is only supported in slot 2 or 4 (single CPU configuration)?
Let me know.
DELL-Chris H
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!743
0
Posted August 21st, 2022 06:00
Yes. What you highlighted is Slot 2. You can refer below links for details on GPU on T6620
732
0
Posted August 21st, 2022 22:00
The docs says the K(epler)4000 consumes up to 80 watt with is a little bit over the 70-75Watt a PCIe will deliver.
Also.. often are special bios settings needed when it comes to memory mapping. Is the K4000 supportet and if so did yo read the docs?
Regards,
Joerg
DELL-Chris H
7 Practitioner
•
9682 Posts
•
48046 Points
783
0
Posted August 19th, 2022 11:00
Joowkim,
You likely need the GPU power cable, part number 3692K. I would start there.
Let me know if this helps.
DELL-Chris H
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!