I have a Dell OptiPlex 790 Desktop that isn't showing the BIOS, Splash Screen, or bootloader. Only after I get into an operating system does it show anything on the display. (This is over a VGA cable, connected to any monitor over any VGA cable. I don't have a DisplayPort monitor.)
Has anyone had this problem before, and do you know of a solution?
There is no secure boot for bios on any 390 790 990. These systems support MSDOS and XP and therefore will NEVER have windows 8.x / 10 secure boot UEFI.
I can't see the BIOS or any of it's errors, so I don't really know what's going on. There are some error lights but they seem to be generic errors. (The status lights are 1, 3, and 4 with a solid blue light, which just seems to be generic. I can change that to 1, 2, and 3 when I take out the SSD. I concluded that the problem was with the SSD, but maybe that's wrong.)
I'd like to get it to display something so I at least know what I'm doing.
System halted! Attention: Unsupported Video Configuration Detected
Action is Required
This computer has an add-in graphics card, but the monitor is plugged into the integrated video connector. To attach the monitor cable to the add-in graphics card:
1. Shut down the computer 2. Plug the monitor cable into the add-in graphics card connector. This may require a video adapter or video adapter cable. (provided with the system) 3. Turn on the computer.
This message should not appear after completing these steps. For more information or help, please refer to the system documentation
I have done this, again. It's just a solid blue light with one, two, and three. (When the system has one memory stick and no SATA plugged in.) There is no error code that is displayed other than the diagnostic lights.
The problem that I am trying to fix is that there is no output on the display.
The SSD was an additional issue, not the one I am currently trying to fix. I am trying to fix this issue first so I can worry about the SSD later. Sorry if I did not make this clear earlier.
Also, I bought my 790 DT as a refurb. The first thing I had to do to it was replace the size 2032 CMOS battery. A low or dead battery can cause all sorts of bizarre problems.
Duracell or Energizer is suggested. Sony lithium only lasted me 2 yrs. when they should last around 5.
speedstep
11 Legend
•
46969 Posts
11023
0
Posted December 8th, 2019 07:00
If you remove all cards from slots and remove all cables except for vga attached to the onboard video you should be able to turn on and see an error.
These models will not show video onboard when a card is in the slots.
That is not a supported video configuration.