UNSOLVED

dragonfly01

updated

21 years ago

0

11990

January 14th, 2006 21:00

PowerConnect 2216 networking

I have 3 cash reg up front of store with 1 ip address and it works fine and when I go to but in my dsl in the power connect It changes my ip for the cash. reg. and then they say sever not found. The power connect is in my enthernet card in my dell computer running windows 2000 I need dsl so the compan can get into my computer so I get credits.any ideas.:smileysad:
  • DELL-Randy

    132 Posts

    392

    0

    Posted January 30th, 2006 20:00

    More than likely: With your DSL router, a single IP address is provided for internet access.  Thus, only a single system may access the internet at a given time.  The PowerConnect switch is a Layer 2 device that provides local connectivity. 

    Your environment requires an additional hardware device capable of providing internet access to multiple systems.  The technology required to provide this connectivity is referred to Network Address Translation (NAT) -- which is not supported by any PowerConnect product.

  • skspt

    1 Message

    392

    0

    Posted February 11th, 2006 20:00

    I am trying to network 2 computers in my office (one in the back and one in the front) i get internet service on the back but cannot get it on the front; i have the modem into the powerconnect then and ethernet line to the back computer; then i have another line from the powerconnect into a cat 5 line that is wired in the wall to the front dest, from there to the front computer...the back computer works fine and when the ethernet line for the front is plugged into the powerconnect only the bottom green light comes on and i cant network the two...please any help would be great!!!!!
  • 392

    0

    Posted February 12th, 2006 14:00

    Well after alot of thinking it does work and no extra hardware was need each cash has it's on address and the main computer all that needs to be done  is to creat a gateway and make a few changes in the modem and then open pcanywere ports on modem and they could get in the only thing is if you don't have a set ip address you will have to call in and I opted to go with the set ip.Thanks for the input:smileyhappy: