UNSOLVED

GreenTea420

updated

18 years ago

0

6828

April 11th, 2009 23:00

Dell E1505 Heat Issues

Hey all, I was wondering if anyone knew much about how hot my E1505 Inspiron should run. Here is the rundown: CPU: Idle: 55-58C Load: Up to 94C GPU: Idle: 58-59C Load: Up to about 82C Memory: Idle: 58C Load: 82C Harddrive: Idle: 49C Load: 53C Is it me, or do these numbers look abnormally high? I've purchased a cooling pad, but it has yet to arrive. I only have a usb mouse plugged in, and have dimmed the screen to try and cut heat output. My warranty has run out, so I think I might pull the laptop apart and try to give it a good cleaning. Any thoughts about these temperatures? Thanks
  • kirkd

    6 Operator

    •

    5241 Posts

    177

    0

    Posted April 13th, 2009 09:00

    The only temperature that seems too high is the CPU at 94C under load. Usually, the GPU temp runs higher than the CPU.

    Yes, blow out the vents with "canned air".

    Download the free I8kfangui, which will monitor temps and allow you to program the fans to cool better than the stock Dell profile in the BIOS. Do this even if cleaning helps the temps.

    It's possible the CPU cooling "heat pipe" is defective or the cooling unit is not making good contact with the CPU because of improper attachment. If you are not afraild of going inside, the laptop, you can check this out.

    When the CPU temp gets to the 90° area, does the CPU throttle down to lower speeds?

  • 177

    0

    Posted April 13th, 2009 13:00

    Thanks for the reply. I have been using I8kfangui, and set my own automatic temperature control. To sum that up, I basically have the fun turn to full at anything over 57C.

    To answer your question, the CPU does not throttle down to lower speeds when it spikes in temperature. I've been tempted to tinker around with the voltage in an effort to control the heat, but I'm a little hesitant. First, I'm not sure how it will affect performance, and second, I am under the impression that Dell usually sets the voltage at a certain point for a specific reason.

    I've been looking at Dell manuals on how to disassemble the E1505. I've never taken apart a laptop before, but I've delved into desktop towers for the past eight years. I think that I will most likely take the laptop apart to give it a good cleaning, and while I'm in there I'll take a look at your suggestions. I do have one question though. If the CPU heatpipe is defective, or not working simply because of age, how will I be able to determine this?

     

     

  • fcastro75

    47 Posts

    177

    0

    Posted April 13th, 2009 19:00

    I have taken a few 6400 apart and the only thing that could be is a lots of dust and or the thermal material between the cpu and the heat sink have started to get old. Unless you have clocked a lot of time with the laptop I doubt the second one. Also I would recommend if your handy to take it apart and not just blow it with canned air. All that will do is blow the dust and dirt onto other parts on the inside which will cause you issues down the road.