UNSOLVED

bobotech

updated

22 years ago

Closed

B

bobotech

6 Posts

0

771

July 30th, 2004 18:00

D300XT startup problems.

I have a d300xt laptop that is not working properly.  Basically, what happened was that the mmc 1 cpu in the unit burned up for whatever reason.  I went ahead and got a replacment cpu  (mmc1 but its a 366mhz p2 model) .  I put it into the system.

i then try to startup and the lights light up for about 2 or 3 seconds then they shut off.

I have seen that this is a common problem with this model laptop, what could be the cause of it?  Any ideas?

Thanks,

Bo

 

  • bobotech

    6 Posts

    79

    0

    Posted July 31st, 2004 18:00

    Well i did a  little searching on this forum and found out that a common cause of  this issue is the cpu not being properly seated in its location.

    So i went ahead and pulled the keybaord off, pulled the heat sink off and then reseated the cpu (the 3 screws holding the cpu down were tight).  Powered it up and sure enough, it worked fine.

    I then figured that since this is such a common issue, i went ahead and put 2 peices of doublesided foam tape on the lower left edge of the cpu (where there is NO screw).  The foam tape was tall enough that it stuck up a little bit.  I then put the heatsink cover on top of it and when i screw ed (that word is not allowed when screw and ed are put together... odd) it down, it compressed the foam tape.  My feeling is that the foam tape will keep enough extra pressure (combined with the pressure from the keyboard as well) so that the cpu won't unseat itself.

    On a side note, the 366mhz pentium 4 cpu worked awsome in this little laptop.  It now registers as a D366XT when its booted up.  My unit did have the A12 bios already before i put the new cpu in but I have read that other people have stuck faster cpu's in their CPi's and they just worked even with older bios's.

    Message Edited by bobotech on 07-31-2004 02:24 PM