
UNSOLVED
M
Maureen0066
4 Posts
0
10588
March 31st, 2004 03:00
XP BIOS Update - should I have done this?
My hard drive went out in my Dimension 8100. Dell replaced it - that was an experience in it's self. However, I I did a clean install with windows XP Pro and updated the BIOS as well and now I'm thinking I shouldn't have done that..maybe? My system clock has gone haywire and some programs are running funny as well as not being able to access some internet sites with my AOL software. Could these problems be because I updated the BIOS?
What shall I be aware of if I were to go back to the A09 Bios? From XP2 And is there any special way I need to do that? Any suggestions will be greatly appreciated!!?? Sorry for the ignorance but, gotta learn somehow right?
Thanks
Responses (5)
Solutions (0)
Maureen
With the XP2 BIOS upgrade for the 8100 model the only difference between that version and version A09 was a fix was added for the E-Support Keyboard button that the 8100 has. Windows XP doesn't support the E-Support software so the BIOS was change to allow for Direct Access. That is the reason Dell recommends the XP2 version for Windows XP users.
You can try flashing the BIOS back to see if that will resolve the problems, but I suspect that your machine is suffering from a new operating system and needs a tweak or two. If you haven't done so already you might consider posting your problems over in the Software - Windows XP forum. There are quite a few XP users that visit that forum and possibly someone else has experienced the same upgrade problems and they know of a solution. I would try this option first before the BIOS flash since there is always a slight element of risk during a flash that you may not want to deal with.
Spider_Bill_200
19 Posts
342
0
Posted April 1st, 2004 22:00
Try a Windows update at Microsoft in case your XP disks are out of date!
Also, check for software upgrades for your hardware (like sound board, etc) at the Dell site just in case there is something out of date there too.
Spider_Bill_200
19 Posts
342
0
Posted April 1st, 2004 22:00
Check here for ideas!
Maureen0066
4 Posts
342
0
Posted April 4th, 2004 06:00
Thanks everyone for all your suggestions!! Greatly appreciated!!!!

Ron43964
1 Rookie
•
67 Posts
342
0
Posted March 31st, 2004 11:00
You can go back to your old BIOS the same way you updated it. I run A09 on my 8100 although DELL recommends the XP BIOS for machines running Win XP. Perhaps you can go into the BIOS and look to see if everything is detected properly. Also, take a look in device manager for any yellow exclamation points, indicating a problem.
Ron