UNSOLVED

goldguru

updated

26 years ago

G

goldguru

16 Posts

0

4586

March 3rd, 2001 04:00

secondary IDE controller (dual fifo) ??


secondary IDE controller (daul fifo)
this device has a problem : Code=29(0x1d)
this device has become disabled you must restart the hardware
see harware doc's
alloc resources: logical configuration=0

driver esdi_506pdr 4/23/99 10.22pm size 24406
how do i re-enable hardware
also it would appear my system info like start up has changed ??also i'hve lost both my dvd & cdrw direct says not supported?
  • goldguru

    16 Posts

    307

    0

    Posted March 3rd, 2001 04:00

    haven't had case open just restored my reg to the 28th & still no d&e drives dvd will eject cdrw wont because it was containing rewritable with direct cd turned off,secondary ide not even mentioned in system config anywhere
  • Mister_Bill

    393 Posts

    307

    0

    Posted March 3rd, 2001 04:00

    Have you installed any other hardware lately? You may have bumpped the connections from the cd ribbon cable. If you haven't , you could try removing the problem device from the system devices list and Windows should locate and reinstall the drivers during bootup.
    (*Usually, some configurations will differ, The secondary IDE is on the motherboard and has the ribbon cable for your cd and rewrite drive attached to it. The primary IDE has the ribbon cable to your harddrive attached to it.)

    Mister Bill



    I would much rather be thought ignorant than stupid,
    Ignorance is curable,
    if you don't know something you can always learn it.
    Stupidity is fatal,
    if you're stupid you won't even realize it!

    ~Anonymous
  • goldguru

    16 Posts

    307

    0

    Posted March 3rd, 2001 19:00

    problem is in bios,need to enter setup on start up by holding down escape key check to see if proper selections are made in advanced for your primary & secondary IDE controllers reselected both & i'm ok again till next time.