
UNSOLVED
Houston We Have A Problem - on startup
Hello PPL :)
Ok i have a Dell Dimension 4300, yes it is old but she still runs like a dream, that is once i get her going.
What happens is that when i power up, after a short period i hear two little beeps and then i get the following message appear.
Primary Hard Disk Drive 0 not found
Primary Hard Disk Drive 1 not found
Press F2 to enter setup of F11 to continue....
Originally i thought that it might be the disk controller on the motherboard playing up or the motherboard itself on the way out, so it stayed there in the corner collecting dust.. I did all the standard things such as swap disks, swap cables.. hoover the lounge..
Recently though i thought i would try again, and purely by trial and error i discovered that when this happens, i can sort it by go into setup.
Under Primary Drive 0 and Primary Drive 1, it states unknown. So i go into one of them, change the Drive Type from Auto to Off and back to Auto, save and exit bios, and bingo she bursts into life.
I can then power off and on ok... it is only when the unit has been powered off for a longer period, say overnight that this problem occurrs...
The current bios is A06 which for that model is the latest...
can anyone possibley shed any light as to what might be happening?
any advice is very much appreciated.
thanks
Dal :manvery-happy:
Responses (17)
Solutions (0)
metalsailer
20 Posts
1185
0
Posted April 28th, 2007 14:00
I would also suspect a Battery, but I would have expected time to be reset. Try changing another of the default BIOS settings. For example, turn off a serial port or change something in the parallel port settings. Then let it sit off. When the hard drive problem comes back, does the other BIOS setting also change back to the default value?Also, you state that you have the latest BIOS. Did you recently flash the BIOS? Did the problem happen after this? How old are the drives? I'm thinking here of the possibility that a recent BIOS flash could have broken support for older hardware.- Changed one of the bios settings, turned pc speaker to off. Left it for a few hours and tried again.. usual story to get going.. checked bios and the pc speaker was still off.I originally flashed the bios well over a year ago... and have not re-flashed since. The disk is the original disk it came with so no changes there and the second disk i also have had in the system for over a year or more...thanks againDal
- Very strange. Just for fun, why don't you try opening up the case and giving all your connections a good dusting (best to do this with the comp unplugged). You wouldn't believe how much dust gets drawn into a computer over the years. It's a total long shot, but I'm wondering if the reason it starts up "the second time" has less to do with the BIOS and more to do with your fan clearing off some connections. Like I said, it's an extreme longshot, but sometimes you have to get creative!
metalsailer
20 Posts
727
0
Posted April 30th, 2007 20:00
My next guess would be a power supply issue. One or both of the hard drives could be "getting sticky" requiring more power to spin up. If the hard drive isn't ready in a timely manner the BIOS code will complain. Try disconnecting one of the hard drives (and setting the Master/Slave switch appropriately). If you still have the problem, try only using the other one. See if you can isolate to problem to one drive.Have you added any new hardware that would be increasing the power requirements? Any noisy fans that might be going bad (with increasing power draw)?When you are in there dusting, try pulling off the power/data cables and resetting them. This might help lower the resistance on any dirty contacts.

Rorsach
510 Posts
1185
0
Posted April 27th, 2007 16:00