UNSOLVED

JonathanSE

updated

11 years ago

J

JonathanSE

10 Posts

0

66727

February 15th, 2016 04:00

PS6210XS 10GB Ethernet Interface connected to Dell PowerConnect 1GB Ethernet Interface

Hello.

I try to initiliaze a new PS6210XS to add it to an existing PS Group.

The existing PS Group is connected to a PowerConnect 6224. 

Is it possible to connect the 10GB SAN ethernet interface to the 1GB Switch Interface ?

The link state is showing as "Down" on the switch CLI when the port is configured for autoneg. 

I tried to force 1GB Full Duplex on the switch port, but it doesn't work better, and the speed is now showing 100MB :

1/g4 Gigabit - Level Full 100 Off Down Inactive

Thanks in advance for your help.

Regards,

Jonathan

  • JonathanSE

    10 Posts

    1311

    0

    Posted February 16th, 2016 00:00

    Hello. Thanks for your answer.

    In fatc I try to connect the 10GB SAN Ethernet port, not the uplink, to our iSCSI switch. The port on the switch is the 1/g4, so it is not the management port.

    So it's just a 10GB Ethernet port connected to a 1GB Ethernet port.

    Regards,

    Jonathan

  • JonathanSE

    10 Posts

    1311

    0

    Posted February 16th, 2016 06:00

    Hello Donald, ok I understand ;-)

    The cabling part was done by someone else, and of course the SAN is in a datacenter, very far away from me, so I cannot confirm if the port connected to the SAN is the good one ...

    Anyway, I will wait for someone to check that point, but considering everything is OK on cable side, do you know if it should work or not ?

    Thanks !