Help

Start a discussion
UNSOLVED

nareshbalakris1

updated

16 years ago

N

nareshbalakris1

5 Posts

0

724

January 10th, 2011 18:00

Cisco Link Failure Alert Configuration

Hi All,

                    We have Cisco 9513 Director, and we have all our storage device FA connected to one modules and the servers are connected on a seperate module. Is there a way i can configure the link failure alerts for  a specific module alone on a a cisco switch to which the storage fa ports are connected.

Whereas i dont want to enable the link failure alerts for the entire switch. Please advice .

Regards,

Naresh

Cell : +65 84085272

Email : nareshb_2001@yahoo.com

  • M

    minksg

    2 Intern

    •

    546 Posts

    306

    0

    Posted January 11th, 2011 05:00

    Hi Nareesh - this question would be better served in the Support Forums..stand by and I'll get it moved.

  • R

    RFritz11

    2 Intern

    •

    244 Posts

    306

    0

    Posted January 11th, 2011 06:00

    Hi Naresh,  I've moved your thread to the support forums infrastructure connectivity where it should get prompt attention. Thanks.

  • D

    dynamox

    11 Legend

    •

    20419 Posts

    •

    87439 Points

    306

    0

    Posted January 11th, 2011 06:00

    you can setup MDS to send errors to syslog, i am sure you can get creative with syslog where you only monitor specific modules.

  • D

    DanJost

    190 Posts

    306

    0

    Posted January 12th, 2011 09:00

    You can (or could in older MDS) disable link state traps on the ones you don't want to see.  It will still show as "down" if you are polling but if you are using traps you can disable the traps for particular interfaces.  A quick google of "mds cli snmp" will get you this info. 

    Dan

Dell Support Resources

Latest Solutions

View More