Solved!
Go to SolutionChanging the memory utilized by SP
Hi,
In Navisphere, you can see the amount of memory being used by the SP's under Properties of the Storagae Array -->Memory Tab. The rest of the free memory is used to set the READ & WRITE CACHE.
Suppose my SP's memory usage is 790 MB of out installed memory of 1024 MB. I am left with 334 MB to distribute between read & write cache. I want to increase the memory for my cache usage. Is there any option or way out to change the memory used by SP ?
Regards,
R.Thandayuthapani
In Navisphere, you can see the amount of memory being used by the SP's under Properties of the Storagae Array -->Memory Tab. The rest of the free memory is used to set the READ & WRITE CACHE.
Suppose my SP's memory usage is 790 MB of out installed memory of 1024 MB. I am left with 334 MB to distribute between read & write cache. I want to increase the memory for my cache usage. Is there any option or way out to change the memory used by SP ?
Regards,
R.Thandayuthapani
- If you wan't to change the cache settings you have to disable the cache; then you can change the settings and then reenable the cache. During the time you'll have a performance impact (due to the reason that to don't have the cache enabled...)
so don't to that when you have heavy load on the system.
best regards
Manfred - You can't change the memory used by the SP itself. What's left is what you can use for caching. But don't worry, the SP's don't use up all your memory; there should be plenty left for reasonable R and W cache and the bigger and better the Clariion, the more memory will be left over for R and W cache.
houndfish
53 Posts
196
0
Posted September 26th, 2007 08:00