Since the Dell alderlake systems are under clocking (4000-4400) ram below the base DDR5 speed of 4800. If we put in Ram that is above that speed will System also under clock them? Will we also have a way to utilize ram at their correct speed?
The specs here list 4400 as the maximum clock speed so yes if you install 4800 it will in all likelihood be clocked down to 4400. This web page has more information on 4800 and 4400.
I am not a Dell employee...I am forum volunteer
Serious work on an E5430 and constantly building and working on an i5-6500 Desktop
there's no turbo speed and there's no XMP profile on the RAM, they aren't downclocking the ram either. DDR5 goes as low as 3200, anything under 4800 is considered energy saving per SK Hynix. Throw higher speed ram in their and in all likelihood it won't post just like all previous Gen Auroras trying to run higher speed, you either get lucky or you don't. The board can only support certain DIM voltages and timings before it refuses to boot
I tend to agree with that. They will stick to the OEM design, as that is what they have been doing with past generations.
You will likely encounter the same issues with aftermarket RAM, or aftermarket fans, or aftermarket cooling solutions as with previous generations.
We will have to see how true that statement is that this is more upgradable than the previous versions, when we see reports coming in from users who have upgraded their R13.
Isn't XMP3 officially supported by intel? why do dell pick and choose the lowest spec and stick to it ? what do they lose by allowing higher speed ram to run ?
Wesleyg1
1 Rookie
•
78 Posts
3087
0
Posted December 23rd, 2021 08:00
Then that is unfortunate